Repeater ,Booster for GSM, DCS, VHF, UHF

Bridge with powerful antennas for boosting your indoor 3G/4G/LTE/GSM/WiFi signal. Stronger signal will give you more internet speed and more reliable connection.
This is a bundle product that consists of multiple products (antenna, cables,...) You will be notified if any of the sub-products is out of stock, when you put the product in shopping cart. We try to keep this product in stock all the time. In case this product runs out of stock we normally get more within 1-2 weeks.

Description The DPF 70/6… is a 6-cavity duplex filter for duplex transceivers.
The DPF 70/6… can be adjusted within the complete 406 - 470 MHz band. The duplexer can be delivered in four different versions according to required duplex spacing. See also “Ordering information” below.
The DPF 70/6… is primarily intended for equipment where the Tx and Rx operate on single frequencies, but it can also, however with slightly reduced data, be used where the Tx and Rx operate on multi channels, i.e. within a certain port bandwidth. In the last case, factory-tuning is recommended.
The filter uses full-length ¼ λ cavities in a compact extruded aluminium housing. The chassis is made of passivated steel, and teflon insulation has been applied in the coaxial cables and in the connectors.
DPF 70/6... is coated with black vinyl to prevent corrosion.
Ordering Information When ordering, please use the table to select the appropriate ordering designation for the desired filter type. If duplex Tx and Rx frequencies are stated when ordering, the duplexers are delivered factory-adjusted. If Tx and Rx frequencies are not stated, the filters are delivered non-adjusted.
Please Note Special configurations of this filter type may be quoted on request. For instance, the filter can be delivered with other connector types, or with flying leads (e.g. RG 316 or RG 400 coaxial cable) terminated with connectors or for soldering-connection.

Description The DPF 2/6… is a 6-cavity duplex filter for duplex radiotelephones.
This duplexer is delivered in a low band version type DPF 2/6 L, tunable within 138 - 156 MHz and a high band version type DPF 2/6 H, tunable within 152 - 175 MHz. These models are again delivered in 3 submodels, each dedicated to work with a certain duplex spacing.
The DPF 2/6… models are primarily intended for equipment, where the Tx and Rx operate on single frequencies, but they can also, however with slightly reduced data, be used where the Tx and Rx operate on several channels, i.e. within a certain port bandwidth. In the last case, factory-tuning is recommended.
The filter has very small physical dimensions owing to the use of high-Q, temperature compensated helical resonators.
The housing is made of extruded aluminium, the chassis of passivated steel, and teflon insulation has been applied in the rigid coaxial cables and in the connectors.
The filter is coated with black vinyl to prevent corrosion.

Description: This duplexer is a passive device that allows multiplexing frequency in radar and radio communications systems. It isolates the receiver from the transmitter while permitting them to share a common antenna, so that to ensure both receiving and transferring can work properly at the same time. Features: Stable Structure: Simple design makes it easy to install, effectively improve the signal of wireless communication in large areas, such as residential areas, shopping malls, hotels, and more.
6 Cavity Design: Each resonant can transmits and receives frequency. The receiving end filter resonates at the transmitting frequency and prevents the transmitting power string into the receiver. The transmitter filter resonates at the receiving frequency.
High and Low disjoint frequency bands: the signals on Low and High frequency band can coexist on one port without interfering with each other.
25W RF Power Handling: Beneficial to improve the output power of the whole machine, improve the efficiency, and reduce the calorific power.
The isolation of this duplexer is more than 75dB, which ensures high sensitivity in signal receiving and transmitting.
Specification: Color: Black Material: Iron Frequency Differences between TX and RX: UHF 3MHz (Min.) / UHF 10MHz (.) TX Frequency: 157.650MHz RX Frequency: 163.350MHz Bandwidth: ±500KHz. Terminal Standard: N-connector. Frequency Spacing: 8-10MHz Insertion Loss: ≤1.0db Nominal Impedance: 50 Ω Isolation: > 75db Size: Approx. 22.5 * 15.4 * 3cm/ 8.9 * 6.1 * 1.2in Package Size: Approx. 26.5 * 20 * 7cm / 10.4 * 7.8 * 2.8in Weight: 1000g Package Weight: 1154g Package List: 1 x VHF Duplexer

Repeater Amplifier indoor Booster GSM DUAL BAND 900/1800MHZ

The RD625 is a digital repeater designed specifically to provide reliable radio coverage in buildings and tunnels. The RD625 has been developed in accordance with the Digital Mobile Radio (DMR) open ETSI standard and can be operated with either digital or analog signals.
Hytera's DMR repeater can be connected to an IP-based communication network with multiple sites. The roaming function is used to provide radios in this radio network with voice and data services across cells.
The RD625 repeater provides a connection to existing VoIP telephone systems on the DMR radio network as SIP subscriber. This allows DMR radio subscribers to hold half-duplex conversations with participants from the telephone network. Telephone subscribers have the option of making either individual or group calls in the radio network.
The RD625 repeater provides a connection to existing VoIP telephone systems on the DMR radio network as SIP subscriber. This allows DMR radio subscribers to hold half-duplex conversations with participants from the telephone network. Telephone subscribers have the option of making either individual or group calls in the radio network.
The integrated power supply of the RD625 automatically chooses between alternating current and direct current. This makes it possible to provide a fail-safe radio signal by connecting the repeater to an independent source of direct current (UPS) in addition to the normal supply of power. If the AC supply fails, the RD625 switches to the second power supply automatically.
With air interface encryption signaling and communications data between radios and repeaters are transmitted with reliable protection.
The RD625's well-engineered design makes wall mounting easy using the optionally available wall bracket. This makes it possible to install the repeater flexibly and conveniently in buildings.
The RD625's well-engineered design makes wall mounting easy using the optionally available wall bracket. This makes it possible to install the repeater flexibly and conveniently in buildings.
The RD625's well-engineered design makes wall mounting easy using the optionally available wall bracket. This makes it possible to install the repeater flexibly and conveniently in buildings.
The RD625 combines transmitter and receiver components, the power supply and the duplexer (optional) in its compact chassis.
The RD625 can be monitored, checked and controlled using a PC-based application. The software supports network access from multiple points and allows administrators to monitor the DMR radio network.
To ensure a high level of security, the RD625 features a repeater access monitor that protect the radio network from unauthorized access attempts.

The GSM 1800 repeater kit is designed for medium sized coverage areas up to 250 square meters. The GSM 1800 kit has been sucessfully and easily installed in all types of application areas including homes, basements, offices, warehouses and larger buildings. The installation process involves placement of the external signal or donor antenna which captures the signal and provides input to the repeater amplifier. The 60dB gain GSM amplifier increases the signal strength before re-broadcasting a clear and powerful signal inside. Boost bars, extend range and stop dropped calls today! The IQ GSM 1800 repeater kit comes complete with GSM 1800 60dB GSM repeater/amplifier
High gain external dual band signal antenna
15 m coaxial cable for connecting donor antenna
AC/DC main power supply
Installation manual and parts Technical Specifications:
Gain ( dB) Uplink Gp≥55, Downlink Gp≥60
Pass band ripple ≤5dB
Guard band rejection (BW-60dB)≤42MHz, (BW-70dB)≤45MHz
I/O impedance 50Ω/N connector
I/O return loss ≤-8dB
Export power (Po) ≥23dBm
Intermodulation Attenuation: ≤-40dBc (Po=13dBm)
Transmission Delay ≤0.5μs
Ambient temperature -10℃～50℃
Power supply AC110～220V + - 10%
Connector Mode N/K for both in-out antenna socket
Diamension 235 x 178 x 25 mm

How many times had to leave your room to get a better signal on your cell phone; Do not let anymore your communications losing ground low signal! The Mini 4G is an amplifier only boosts the 4G signal rather than voice frequencies. Give solution with Mini 4G in places with low signal such as Home, Office, Business, underground buildings, warehouses, hotels, underground parking, conference etc.)
With the problem of incomplete communications signal amplification system permanently solve and missed calls. The kit includes everything you need to install the amplifier easily and quickly.
This unit provides a reliable and economical solution in places where the mobile signal is low intensity. The Mini 4G is designed to improve and Strengthening of 4G mobile signal coverage up to 250 sqm. The Mini 4G improves the strength of the data signal having a weak signal through an external antenna .Then feeds the signal to the amplifier / transponder and this in turn transmits the amplified signal. Installation is simple and takes minutes. For optimal performance the external antenna should be placed in position with the strongest signal strength. Note: Amplifies only 4G data signal rather than voice The kit contains the following:      Mini 4G Amplifier
     External dual band antenna
     Internal antenna whip
     10 m cable
     AC / DC power supply
     Use / Installation Manual

The PMX 900/1800 Mobile Repeater kit is a high powered kit which boost signal strength and coverage for all GSM voice networks for any European services. The PMX 900/1800 is compatible with all GSM 900 and 1800MHz services and guaranteed to provide improved coverage for your mobile phone signal over an area up to 1000 sq m. The kit comes complete with everything you need to increase signal strength and strop dropped calls. This product is simple to install, comes with 100% free technical telephone support. Dual Band GSM 900/1800
70 dB gain
Coverage up to 1000 sq m
supports up to 75 users
High gain signal antenna
Works with ALL GSM voice networks
Product Description The PMX GSM 900/1800 is designed for medium to large sized coverage areas up to 1000 square meters. The PMX Mobile Repeater kit has been successfully and easily installed in all types of application areas including homes, basements, offices, warehouses and larger buildings. The installation process involves placement of the external signal or donor antenna which captures the signal and provides input to the repeater amplifier. This PMX 900/1800 system is compatible with all GSM mobile phone voice networks. The 70dB gain dual band amplifier increases the signal strength before re-broadcasting a clear and powerful signal inside. Boost bars, extend range and stop dropped calls today! The PMX GSM 900/1800 Mobile Repeater kit comes complete with PMX 70dB gain dual band GSM 900/1800MHzrepeater
High gain external dual band signal antenna
10 m coaxial cable for connecting signal antenna
AC/DC main power supply
Installation manual and accessories

There is a solution with the Redutelco POWER MAX DUAL BAND 900 / 1800MHZ Signal Amplifier in Low Signal Locations such as House, Office, Enterprise, Underground Buildings, Warehouses, Hotels, Underground Parking, Conference Rooms etc.)
With the signal-enhancing system, you are finally solving the problem of incomplete communications and missed calls. The kit includes what you need to install the amplifier easily and quickly.
This unit provides a reliable and cost-effective solution to locations where the mobile phone signal is low-intensity. The POWER MAX DUAL BAND is designed to enhance and enhance GSM cellular phone coverage of up to 1,000 m². The POWER MAX DUAL BAND improves signal strength on your mobile phone by taking the weak signal through an external antenna. It then feeds the signal to the amplifier / transponder and it in turn relays the signal enhanced. Installation is simple and lasts minute. For best performance, the outdoor antenna should be placed in the position with the strongest signal strength.
The kit contains the following: Redu Dual Band GSM Amplifier 1 pcs
Outdoor Quad band antenna
Inner wall panel antenna
10 m cable
AC / DC power adapter
User / Installation Manual

The In Building PRO Dual Band Repeater Kit is compatible with all European mobile phone carriers (except 3G) and effectively provides a strong and reliable phone signal in places with poor reception. The In-Building PRO kit comes with everything you need to boost coverage in your area! This product is simple to install.
Dual Band GSM repeater
55dB gain
Coverage up to 500 sq m
Simple Installation
Supports 50 simultaneous users
Works with all European Carriers .
Installation of the In-Building PRO repeater is simple and takes minutes. Just mount the external aerial antenna and connect to the repeater input port. At the output of the repeater connect the indoor coverage antenna then connect the power. For best performance the external aerial should be mounted in the location with the strongest signal strength. The effective coverage area of the unit depends on the input signal provided from this antenna.

Specifications
• Gain (dB) Uplink Gp≥65, Downlink Gp≥70
• Pass band ripple ≤5dB
• Guard band rejection (BW-60dB) ≤42MHz, (BW-70dB) ≤45MHz
• I / O impedance 50W / N connector
• I / O return loss ≤-8dB
• Export power (Po) ≥15dBm
• Intermodulation Attenuation: ≤-40dBc (Po = 13dBm)
• Transmission Delay ≤0.5ms
• Ambient temperature -10 ℃ ~ 50 ℃
• Power supply AC110 ~ 220V + - 10%
• Connector Mode N / K for both in-out antenna socket
• Diamension 235 x 178 x 25 mm The kit contains the following:
SB PowerMax 3G Amplifier
External dual band antenna
10 m cable
AC / DC power adapter
User Manual / Installation

Amplifier indoor GSM booster for 20~70m2

The new PowerMAX 4G is specifically designed for Everything Everywhere's 4G EE High Speed Data Network. This product comes as a complete kit and will enhance 4G coverage for EE network for areas up to 1000 square meters. The PowerMAX 4G kit includes everything you need to ensure strong and reliable signal. This product is simple to install, comes with 100% free technical support.
• 4G EE 1800MHz Amplifier
• 60dB gain
• Coverage up to 1000 sq m
• Simple Installation
• Supports 75 simultaneous users
• Works with 4G EE Network

Cell Phone Lightning-Proof Signal Booster 2G Vodafone, Wind w/ 0.6" LCD.