M&P

Why choose this connector?

• Compression design with double seal that ensures better protection against infiltration of water, humidity and condensation.

• Easy installation and welding instructions included in the package (no braid soldering needed).

• Dramatic suppression of the background noise, improvement of screening attenuation and insertion losses.

• The surfaces are treated with a special alloy called Smart3-Alloy®: it is corrosion-resistant and hypoallergenic.

• The new designed pin prevents excess of tin and the consequent heating, which damages the dielectric causing an uncontrollable alteration of the electrical properties of your cable (differently from standard PL259 which is exposed to strong thermical stress).


Product dimensions: 2,1cm x 3,7cm

Wrench size: 11mm & 13mm

Connectors are sold individually, image is for illustrative purpose.

WHY CHOOSE THIS CABLE:

• Best 5mm (.200") coaxial cable available for performances.

• 3,6dB/100m less at 50MHz than RG58 C/U, exceptional for applications in HF, mobile and portable, QRP, CB Radio, etc.

• Suitable for direct burial and totally waterproof.

• Also weatherproof and perfect for outdoor use.

• Superlative robustness and resistance thanks to the PE tearproof sheath.

• Incredible lightness: 1,4Kg x 100m less than RG58 C/U.

*The aluminium braid cannot be soldered. Our connectors are designed to avoid the welding on the braid.

ATTENTION: To install the connectors in polyethylene cables like this one, additional procedures must be carried out, as it has a more robust sheath than PVC ones. Infact it requires two longitudinal cuts to easily insert the component between the braid and the sheath without breaking it (alternately you can soften the polyethylene sheath using a hair dryer).

The most flexible 10,3mm cable, perfect for tight bendings and rotor antennas.

• The best attenuations for a stranded core 10,3mm coaxial cable.

• Best velocity ratio in the coax range: 87% !

• Excellent performances with limited signal loss even at higher frequencies and long distances.

• The best cable for Wi-Fi signal extension, Router, 2G-5G, Hotspot, LoRaWAN protocol, Gateway IoT.

Given a power fed to the X value (any value expressed in Watts), the actual power output of the cable is shown in the table in the form
of remaining percentage. (for example, if we use a cable such as
M&P-HYPERFLEX 13, entering 1000 Watts over a length of 35m, at a frequency of 144 MHz, there remains 74.7 % of 1000).
For maximum applicable power, see the Power Handling of the cable concerned. From these values, have already been deducted the
SRL values, typical of each one of our models, for the respective frequencies.
REMEMBER: Make sure to match the line accurately!